Brushless system questions

[holy_inferno]

I've just installed the CC2068 Mamba Comp brushless power system and have a few questions...
-When I tap the throttle on my transmitter, the motor runs for around 2 seconds before stopping, I can't brake or slow down for that period...
-When the motor's running, I can't seem to control my servo.
-There doesn't seem to have any proportional control, a tap on the throttle the motor runs, when I reverse, I can't stop reversing.

Please help me answer these questions

Thanks :)

[Rob L]

I just finished moving my 6800 from my RC18T to my Half 8. Sounds like you haven't programmed the ESC yet or if you did, it needs to be done again. Programming or reprogramming the ESC should fix these issues.

[holy_inferno]

Found the problem...receiver interference as it's right next to the ESC...Now i need to find out how you guys set up your Brushless System in the Mini Inferno :)

[plain_simple]

It shouldnt had any interference because of beeing close. I beleive that re-programming it is the best way to go.